When your 4WD starts acting up—slipping, making grinding noises, or not engaging when you need it most—there's a good chance this drive shaft is the culprit. This replacement gets power flowing smoothly to your front axle again, so you can pull through muddy fields, climb hills with heavy loads, and keep working when conditions get tough. Don't wait until you're stuck to find out your front drive isn't doing its job. What You're Getting Precision-machined splines that engage cleanly with your front axle components Heavy-duty construction built to handle full engine torque in 4WD mode Direct replacement design that fits right in without modifications Quality materials that stand up to the constant stress of front-wheel assist work Built for Real Farm Work This shaft fits a wide range of New Holland tractors from the utility-sized T6 series up through the powerful T7 models, plus the proven TM and TSA series machines. These are the tractors handling everything from loader work around the farmyard to pulling wide implements across hundreds of acres. Whether you're running a compact T6.120 or a big T7.260, this is the same quality drive shaft that transfers power from your transmission to the front differential. Made to Last Farm work is hard on driveline components, and this shaft is built accordingly. The machined splines maintain their tolerances season after season, while the steel construction handles the twisting forces that come with modern horsepower levels. It's designed to work smoothly with your existing universal joints and carrier bearings. Installation Notes Plan on dropping some front axle components to get this installed—it's typically a 2-3 hour job if you're doing it yourself. While you're in there, it's smart to inspect the universal joints, carrier bearing, and differential seals. If the old shaft has been worn for a while, it may have caused additional wear to connected components.
